Recent content by Turbomrdeuce

i need the vacuum line diagram for a 93 v6 4runner with a 3.0 not the egr thats under the hood but the vacuum lines to the left when your looking into the engine. Thanks

hey guys got a 93 4runner auto 4x4. new freshened up motor. Im not sure if i hooked all the vacuum lines back up how they should be, but the car runs and drives yet is severly under powered. It cant even free rev to redline in park or neutral. Timing is good, compression is good, no check engine...

tried everything so far, im taking off the front cover to see if maybe the belt didnt jump a tooth

got a 93 4runner 4x4 auto v6, the car crank, has fuel and spark but it wont start. Timing is good, i tried unplugging the efi fuse and replugging it back in still nothing. Tried spraying starter fluid down the throttle and still wont fire. The spark plugs are not wet but they do smell like...

Hey guys I got a 93 4runner auto 4x4 I just pulled the motor out and refreshed it. I put everything back in and when I go to crank the car nothing happens. The radio turns off and the clock dims but no cranking over nothing. I checked the starter and the relay. The battery is brand new I even...

Bumpity

Bump

Get a big ass monkey wrench there's a part on the cams that you can put it on it's made just like you could use one start turning until it gets pressed against the side of the head. Then with a breaker bar break the cam gear bolt off

Bump aanyone? Mine are a little tweaked

I need the transmission oil cooler lines that are on the transmission for a 93 4runner 4x4 auto with a v6. Thanks

heres just a update on the car motor was pulled out all new fluids all new gaskets including front and rear main oil pan gasket etc, new water pump and new timing belt.... i shoulda done a write up but no time with school. the motor is back in the car going to finish it sometime this week.

thank you sir i was planning on doing the cap and rotor too. Why do i need a cam gear remover? cant i just loosen the timing belt tensioner and remove the belt? Im pulling the engine because im going to replace both rear and front main seals and oil pan gasket. Im changing all the gaskets I do...

really not one person?

Hey guys new to the forum just had a question. I just purchased a 93 4runmer 3.0 4x4 auto which has a bad head gasket. I'm about to tear the motor out tomorow morning I have a complete engine gasket kit so no worries there. My question to you is besides replacing all the fluids and putting in...