Recent content by WARunner

Aside from the crooked wheel thing. Does anyone know what could cause an oil leak on the starter motor? I fixed the big leaks and cleaned everything. Some mirror+Flashlight work shows the Valve Cover clean 1,000mi after fixing that. However, I keep seeing a very small drip form on the bottom...

Mine is lifted 2in but had a perfectly straight wheel until I pulled the rack to do the lower control arm bushings and outer tie rods. With that in mind, a straight wheel seemed reasonable to me as its all I have ever known with this truck. I don't know if my rag joint is a tooth-off or not, it...

Steering wheel off My steering wheel is at 11 o'clock instead of 12 on an otherwise good alignment. Can an alignment fix that or do I need to pull the rack to adjust the spline? This happened b/c I pulled my steering rack and got a Firestone Lifetime alignment after. My guess is that I missed...

my valve cover gaskets (done by prev owner) went bad even faster than that :(. I agree with the other user that they prob used a cheap gasket and didn't replace the half-moons or cam caps

I pulled my steering rack out and let every little bit of PS fluid/ATF drain out. How should I go about filling it back up without a mess or dry running the pump? With the batt unplugged I put about 0.7 QTs into the res and moved the wheel lock to lock for a while. The fluid level is maxed out...

I think you're right. Upon re-visiting it, the thingy fits pretty snug. Overnighting some high temp JB Weld :)

Do I need a new Valve Cover or JB Weld? Fixing some oil leaks on my 1998 V6. and noticed the breather elbow coming out of my driver-side valve cover is loose. It definitely had some oil residue coming out of it. It feels snug-ish if I push it back in. However, I don't know what's intended to...

Your truck is gonna make it to a million miles, isn't it?

Lad seemed like he'd use it well. Owned an older one and was good at turning a wrench. Good on him

Non-chlorinated brake cleaner or degreaser and water off the car for me