Recent content by Webbuff

PM sent

Be aware of the bearing cup. I rebuilt my axle once then had to do the passenger side again cause the seal leaked again. Turned out the bearing cup on that side was worn and the bearing ended up just spinning around inside it. I also had a grinding noise on that side before the last rebuild.

Looks like your rocking the stock lower arms at least. What are you running for your suspension, especially for the front?

Need to replace my front driver side fender, I am located in Montana (Missoula) so hoping to find one close by. Reply to thread or PM me with price/location.

Yeah Scramble, this is what I was thinking. I will install it in when I back at the house next weekend and follow up. NissanH, appreciate the response. The contacts were indeed the same shape and I confirmed good contact with the plunger before re-installing it. I think the rest is all covered...

Starting issues, next steps help. Problem: When I turn the key in the ignition I hear a click and that is it. After searching and watching a number of videos I have tried the following: Replaced the contacts in the starter, plunger is good just cleaned up the contacting surface. I replaced...

I have a 97 and installed the black ECU with my swap. Works fine :)

They did the install, but used a donor harness from the donor vehicle, etc. Since they installed it all the wiring was well-placed/length and even allowed them to relocate some items to tidy up and organize the engine bay nicely. I was speaking more to their quality of work. I would not...

I will say one thing, TOS is a good company. I had them do my 3.4 swap into my previous 88 4Runner and it was very clean. Totally recommend them and their work.

Urban Dictionary: FIFY I couldn't resist :)

@Chim, 4bangr - I am assuming that you didn't have to touch the crush sleeve, etc. If not this might be how I do it. I think I will start with my original 3rd member to see what all is involved there (and if I can even get it off since it is loose). 4bangr - Yeah I was really surprised as...

Yeah I will measure out the flanges and confirm, but this was the way I was swinging also. Thanks for the reply.

I have an E-locker I had originally purchased to install in a 1st gen 4Runner some years back. Decided since I had to replace the axle seals I would go ahead and do the swap in my 97 4Runner. I bought a stock housing for the e-locker and got everything re-built and the locker installed. The...

Done

I would be interested. Need both currently but price has always been a concern. A built in air-tank would be awesome. I would also be interested in the tire swing away for the back.