another Hella mount

[toyata]

I wanted to mount some hella lights, but didn't want them low by the bumper. So I made a bracket using 1" sq tubing bolted to the two brackets that attach to the bumper.Flanges are welded to the end of the sq tubing. I then welded two 1/4 x 1 1/2 x 8 1/4 barstock. This puts the lights above the bumper. The lights are Hella FF1000. I'm using a Taco switch and have it wired so thet only come on w/the high beams.

 

[toyata]

heres the mounting bracket. not the best pics, but hopefully you get the idea

 

[MAC4Runner]

Nice, clean install :bigok:
Can you post up the dimensions of the brackets?

 

[toyata]

The size of the bar holding the lights are on the 1st post. If you need the size of the 1" sq tubing, I'll have to get that when I get home.

 

[MAC4Runner]

The size of the bar holding the lights are on the 1st post. If you need the size of the 1" sq tubing, I'll have to get that when I get home.

Yes please.

 

[toyata]

flanges are 1/8 inch thick. shaped like the existing bracket on the 4r.The tubing in back is 32" tapering to 31 1/2 in front. I added two extra pieces of tubing in front of the long tubing to help support the barstock that holds the light. Each short piece is 2" long and is 3 1/8" from the edge of the flange. I you look at the 2nd pic carefully, you can see the small tubing under the barstock. Hopefully I explained it well enough for you to understand.

 

[Falls]

Very nice clean job !!! I like it .

I want a Westin Safari bar with lights on it but am afraid of them being to close to the ground.