After ten years of enjoying my '94, and rebuilding the engine after a blown head gasket (found about the recall too late), I'm ready to start upgrading/repairing my Little Red Friend.
Does anyone recommend one brand of ball joints over another? If so, why? I am a moderate off-roader (no Moab, but lots of rough desert road/track/no track at all).
Recommendations on getting my bearings done? Things to look out for?
And what's the best way to get rid of rear-end sag? My baby is looking a little like a worn old mare instead of the Stallion I think it is!
Thanks for your adivce! This is my first post.
Does anyone recommend one brand of ball joints over another? If so, why? I am a moderate off-roader (no Moab, but lots of rough desert road/track/no track at all).
Recommendations on getting my bearings done? Things to look out for?
And what's the best way to get rid of rear-end sag? My baby is looking a little like a worn old mare instead of the Stallion I think it is!
Thanks for your adivce! This is my first post.
