Getting ready to install these this weekend and want to make sure I have all the correct items. 5100's and dobinson springs and I ordered the KYB top hats from amazon that were recommended on here. Are there any additional parts that are needed or parts from the original to put those together?
Bilstein 5100 assembly?
- Thread starter arehman11
- Start date
Register to hide this ad
Decipher
New member
Not that I can think of. You even went above and beyond most by getting the new top hats.
Which setting are you using for the front? I saw a good tip about marking the positions on bolts so when you reassemble the unit your alignment isn’t crazy off and dangerous to drive.
Speaking of which, get an alignment ASAP.
Sent from my iPhone using Tapatalk
Which setting are you using for the front? I saw a good tip about marking the positions on bolts so when you reassemble the unit your alignment isn’t crazy off and dangerous to drive.
Speaking of which, get an alignment ASAP.
Sent from my iPhone using Tapatalk
Yep was planning on marking the adjustment cams and using those as a guideline. I'll be using the zero setting on them.
I think it was recommended on the two lower 19mm on the control arms?
Nickademus78
Member
Did the KYB top hats include the stem cushions and washers needed for assembly? I have the same setup and the ride is amazing.
