Coil spacers VS New Springs

[mudeater43]

Ok, the new guy has been looking at lifts. I am interested in a 3" lift, and looks like toytec/OME has a great deal on a trusted set-up. My question is this...since I have a 99 with the taller springs, over a 96-98 and 2001-2002, should I use a coil spring spacer to maximise the lift, for a full 3" since I do not have much sag, or should I go with the 3" OME? My though process is that the OME will only NET me about 1.5- 2" of lift, whish is hardly worth the effort.

I was considering using the coil spring spacer and the best shock set-up I could buy to keep the firm ride and take out any type of body roll.

Can the experts give me some ideas? I have seen a few rigs in the gallery that are sweet- Lee and Ric, looks like you guys have the set-up I want...Plus the black is too bad ass!!

Also, I have seen the term Cornfed Spacer...what the heck is that, and do I want it?

 

[Elton]

look around over a yotatech.com

 

[mudeater43]

CS VS Springs

Elton-

I did look on yotatech and even posted a thread asking the same question but I could not find anywhere the comparison is addressed.

 

[numba1runna]

Another thing you might want to think about is are you buying the lift for looks or for offroad? or both.

 

[mudeater43]

Lift

The Rig will be used for 80% daily driver and 20% offroad- occasional Moab trips- nothing to crazy. I had a Jeep Wrangler with 32" and a 3" terra-Flaex supsension lift and want the same set-up for the Runner, and would like to run the same trails ( Mt. baldy in COS, Spring Creek in Denver, etc.) Ride is important, I am not looking for any improvement to the current ride, but I do want to avaoid a rougher ride, or body roll / softness.