Fender Flares

[red4runner]

Long time lurker first time poster. Okay, I have a 1997 4runner sr5. I have the black factory flare with running boards. I took the boards off and the flare ends 4-5" above the bottom of the body. Is there a part I can purchase to finish the end of the flare? Will Tacoma front flare fit the 4runner? I appreciate the help.

 

[murph73]

I have the same question. Maybe we can revive this post. See attached with running boards removed. I have since removed the rear mud flaps as well.

 

[RonMAIDEN]

Mine never had running boards on it as mine has the frotn mudflap pices which are available but kinda pricey.

Murph,why did you remove the rears?

 

[murph73]

I didn't like the way the wheel was sitting after installing the Revtek spacers - especially compared to the front. Looked too confined in there.

 

[1fast_e]

I think you can purchase a mudflap insert that would finish off your front flare.

 

[RonMAIDEN]

Look at this page at the bottom set of pics and he has his boards removed with the front mudplap piece in place.

http://www.top4runners.com/ja/pics.html

 

[jminz]

I know this is an old thread, but I'm looking for the same thing and found the Toyota part numbers for these. The part number for the passenger side splash guard is 00547-35961PF, and the driver's side is 00547-35966DF. They run about 35 bucks apiece.

 

[smallfry]

Contact Shannon (aka Tacozilla) over at Tundrasolutions or
www. ttora.com

I just got those parts today, they cost a little over $50.
If I remember right he works for Toyota of Dallas

 

[jminz]

Hey Smallfry, or anybody else, have pics of what the splash guards look like after installation with the running boards removed?

 

[RonMAIDEN]

http://www.top4runners.com/ja/cgi-bin/image.pl?ja/pics/pallisades_norb_drivers.jpg

http://www.top4runners.com/ja/cgi-bin/image.pl?ja/trails/ec4rj01/ja_down.jpg

http://www.top4runners.com/ja/additions1.html#splashguards

 

[jminz]

alright, thanks a lot