Fox 2.0 rears with OME 2895E

[uplusd]

I've searched and haven't found any information on this combo. Will the OME 2895E work with the fox 2.0 rears that are rated for 0-1.5" of lift? The other option is the fox 2.0 rears meant for 2-3" of lift. The specs on the 2895E says 2" of lift, however the forum vendor I purchased them from stated they're closer to 1.5" of lift and had me buy the 0-1.5" version of the fox 2.0 rears. Would appreciate some input before I end up putting the wrong spring/shock combo on the rear.

Thanks!

 

[uplusd]

Typically the OME 2895E Coils provide 2'' of lift for a 5th gen 4runner. They are known to provide 1.25'' of lift on a 4th gen 4runner. I believe you're going to need the 2.0 Fox Shocks for 2''-3'' of Lift.

What if I have third row seats? Will that help bring the 2895E down a bit?

 

[spizike9]

I believe those are the same springs that came in my kit. Mine were the Factory 2.5 resi setup. I believe the vendor set me up with the 1.5" shocks as well. I didn't even question it because they are a site sponsor and figured they knew what they were doing. Hopefully everything is ok on mine.

 

[scbrown333]

I've searched and haven't found any information on this combo. Will the OME 2895E work with the fox 2.0 rears that are rated for 0-1.5" of lift? The other option is the fox 2.0 rears meant for 2-3" of lift. The specs on the 2895E says 2" of lift, however the forum vendor I purchased them from stated they're closer to 1.5" of lift and had me buy the 0-1.5" version of the fox 2.0 rears. Would appreciate some input before I end up putting the wrong spring/shock combo on the rear.

Thanks!

Resurrecting this old thread because I'm looking to do the install on this same set-up tomorrow. Fox 2.0 (0-1.5") rear with the OME 2895e springs. I'm curious what you decided to do and what your thoughts are on the set up. I too, had a site sponsor tell me the shocks have enough travel to cover, but would like to hear from someone with first hand experience on the set up. Thanks in advance.