I'm trying to setup my 4runner with new rims since I'm upgrading my tires. I will be running 315x70x17 good year dura trac. Has anyone ever run this setup on their rig? This is going to be installed on a 2006 Toyota 4runner sr5 with a stage 3 lift icon upfront, arb bull bar, all pro 3.5 spring rear with adjustable Toytec control arms and pan hard, CBI rear bumper 1.5 body lift. Any help would be appreciated. Thanks.
Help with back spacing
- Thread starter ryanberls
- Start date
Register to hide this ad
I have Bilstein 5100's set on 2.5, rear Daystar 1.5, and a 2.5" body lift. Lots of trimming but the fit and run great! Your body lift is smaller, but your suspension lift is bigger so you should be close or a little higher than me. Take it slow, flex it out little by little and trim where needed. I marked mine with a sharpie and then cut with an oscillating saw and then cleaned up the edge with a razor.
Check out my thread, I have pics up that may help some.
preacher35
New member
My guess is that you are going to have to do the "BODY MOUNT CHOP".
Body mount chop - Toyota 120 Platforms Forum as
Body mount chop - Toyota 120 Platforms Forum as
