Installing Aftermarket Intake

[trd_style]

I bought this intake from ebay. It's for a 4Runner 3.4L V6. Question is, i know how to install a simple short ram intake but the problem is, i don't know where that MAF could fit into that slot? Last night, i only installed the filter with the original stock intake, but still figuring out where i could put the MAF. If i have a another 3 by 3 inches silicon, i could connect the stock adapter into the new filter. But then i have to close up that empty MAF slot. Here's a sample picture.

 

[AlexJet]

MAF should have perfect fit to that rectangular hole on the tube.

 

[trd_style]

well, it's an adapter MAF sensor which you can't take it out. it's not where you can unscrew it and put it into the new intake. but it's okay, i just hooked up the original MAF sensor tube into the new intake and duct tape the hole so no 'bad' air would go in.