installing clear corners & pass side taillight

F

FishRunner

New member
I have looked through the "search" on this forum and on the web... but no luck

Anyone have any info on istalling clear corners on a 3rd gen? Also, i managed to crack a taillight and will be replacing it also.

I know it is pretty basic, but since this is my first mod... i want to do it right.
:confused:

thanks in advance
 
Register to hide this ad
I got nothing on the taillight, but the corners are easy. Just pop the hood, you will see one screw close to where the headlight and corner light meet. Just unscrew that and the corner just slides out.
 
Taillights are pretty easy just unscrew the two or three visible screws and slide the taillight either left or right depending on what side taillight your are replacing, Hope this helps
 
If you still have the manual for your 4Runner, there are instructions with pictures showing how to remove all lights.
 
nice pics!! real clean

i love the painted underbody
i also see you pulled your badges... i'm still up in the air
do you have any shot from the rear?

i also like the photoshoped pic
all black with the smoked lights an black grill is a good look
 
This is the best rear shot I can find for now:

l_855b348ff30977cb29d032cf59acc675.jpg


I removed the badges after they had been on there for 3 years. I can still see faint lines of where some of the badges were but you really have to be looking for it.
 
so the taillight came today
it was SUPER easy change
2 screws and the thing pops off

i used the existing harness and bulbs (i only cracked the lens)

now i have 3 brand new bulbs and a new harness

i would have taken a pic... but it was over too quick
(that sounds bad):runaway:
 
You must log in or register to reply here.

Members online

Total: 460 (members: 3, guests: 457)

Forum statistics

Threads
278,307
Messages
3,554,054
Members
248,016
Latest member
Advally Service

Share this page

Trending content

Back
Top