Polish Power
New member
I apologize in advance if this is redundant, but my searches so far haven't resulted in a whole lot of help. I recently started throwing the p0325 and p0330 knock sensor codes and am wondering how to proceed. I'm wondering what the chances are that there is an issue with the circuits or sensors themselves, or if there is actual knock occurring. Its hard to imagine both sensors going back at the same time, but I guess not impossible.
I should also mention that the knock sensor code coincided with my (in)decision to put a can of seafoam in my gas tank in an effort to clean things up a bit. If this caused any premature ignition, I can see why the knock would occur, but it has been about 2 months and a few tanks of gas since then...maybe any knocking that did occur damaged the sensors?
I should also mention that the knock sensor code coincided with my (in)decision to put a can of seafoam in my gas tank in an effort to clean things up a bit. If this caused any premature ignition, I can see why the knock would occur, but it has been about 2 months and a few tanks of gas since then...maybe any knocking that did occur damaged the sensors?
