looking for pics of 2-1 cornfed lift
- Thread starter 06sr5
- Start date
Register to hide this ad
Fro-Runner
New member
06sr5 said:
Oh man! I'm not trying to be a smart arse or anything because the mods will lash me with a stiff wet noodle but please do a search. From the home page if you look just below the ads you will see a few small buttons. One of them is the search button! Click on it and then just type in a few search words such as daystar lifts and you will be amaze at what pops up.
Good luck and welcome to T4R.org!
:bigok:
No offence but I have done that and I have had no luck with finding anyone with a picture of a corn fed 2-1 lift. I found plenty of daystar 2.5 inch lift and corn fed 3-2 lift but no pics of 2inch front 1 inch back. If you know of one please direct me there and I will be more than thankful. Untill then I don't think the mods will have a problem.
MW 4Runner
New member
06sr5 said:
Search member "alexjet"... he had a 2&1 kit installed at one time. There are some pics of his truck with that kit on it on here somewhere, I remember seeing them.
HiVel-JR
New member
Call Jason at Burtman, he will help you decide. Granted he sells the cornfed, but he will not push it on you. I am getting a 2/1 cornfed, they just look better built to me than the daystar, and I have not seen one complaint about the cornfed or the daystar...
spent four hours searching out this topic...
I am waiting until the middle of February to buy it. Hope that helps
spent four hours searching out this topic...
I am waiting until the middle of February to buy it. Hope that helps
Fro-Runner
New member
06sr5 said:
Hmmm...... no offense but you must have used the wrong search settings. I clicked over to the search page and entered this phrase in the search area: "I've been cornfed". Then I moved the mouse pointer over to the match partial phrases and clicked on it. The search returned 3 pages of cornfed threads. I am POSITIVE that one of these threads will have some pics. Just to save you the time of searching...... here is the link to my search return of those three pages: http://www.toyota-4runner.org/search.php?action=showresults&searchid=1396041&sortby=lastpost&sortorder=descending
P.S. You will NOT be able to plug in numbers during a search. It will tell you to use full words as this search setup will not allow numbers. You are going to have to search every thread for what the 2" front and 1" rear cornfed lift that you are looking for. Please enjoy as I believe you will find what you are looking for within one of these threads. I'm sorry that the forum won't allow you to just plug in the numbers and get exactly what you are after.
P.S. #2--- Be sure to look for links in the posters signature at the end of the message. Many here have links to photos of their 4Runners which are located at other photo sites. You can sometimes just click on the wording such as "PICS", "My Truck". "see my Runner here", etc, etc and link up with photos. Good luck again.
Last edited:
MW 4Runner
New member
06sr5 said:
You probably arent having much luck, I tried searching but there isnt much written about custom 2&1 kits...
This post shows Alexjet's and I'm almost positive that this was taken when he had the 2&1 kit installed.
The only other mention of one that I found was HERE. But I dont think he ended up sticking with that size from reading other posts. Try emailing or PMing Jason Burtman, he might have a pic from one of those custom kits.
06sr5 said:
Don't worry about that,its ok to ask for pics and you tried a search, sometimes with certain terms its hard to do a search correctly. No worries !! Not many have that lift so it would be a difficult to find lot of pics on it.
Never could understand why people pipe in with a comment like do a search. Why even bother to respond with such a comment. There probably is not a topic on here that hasn't been asked over and over , it's not a big deal, plus someone might have new development or pics since the last post. Like Hivel for instance is waiting to put his 2/1 lift on if he has not already done so, and can shed light on his findings better than on old post could.
Good luck with the project and welcome to the site.
Jason B
Official Vendor
HiVel-JR said:
Due to much demand, new options are now available on the site. These are the most popular and most demanded.
4th Gen Lifts Kits and Leveling Kits
kickinasphalt
New member
Jason B said:
Sweet!
*wishlist*
Member
not the best picture but i agree that there aren't many pics of the 2/1 kit on here. so here's my contribution for now. the front at times is still a little low but much much much more even than when stock. it also easily evens out with some weight in the back. this isn't a good picture but gives an idea of the 2/1 with nitto terragrapplers. the 4r in the pic is also on a slight slope. btw, anyone interested in buying the merc on the driveway? lol.
josh220
Banned
Falls said:
Because with the 2/1 there is still a half-inch rake to it. Although it is a lot better than the stock 1" rake, it's still not perfectly even on flat ground. It still needs a little more in the front, or a little less in the back. So a 2.5"/1" would also work if you didn't want to go 2"/.5"
