Lumbar Switch, 3rd GEN, $15 Logansport, IN.

[California4runner]

$15 Free Shipping or $10 Local Pickup, Used Condition(Works) Logansport, IN.

$15 Free Shipping or $10 Local Pickup, Used Condition(Works) Logansport, IN.

Note;
I personally Wrapped it in duct tape and wedged the switch in snug Worked just fine for me.

 

[cnpellegrino]

Are any of the clips broken that hold the switch into the seat?

 

[California4runner]

The plastic bit that connects the switch to the wiring connects just fine and stays in place if you see those little holes 2 on each wide side that's on the back end that's where the plastic bit also connects those are hole for the clips aswell, but the clip that keeps the switch in place of the seat did wiggle out.

Again what I personally did was wrap the switch in duct tape and wedged the lumbar switch in good n tight, worked just fine for me and it never popped out I swear it fit and looked like factory.

TBH It took a couple of times to find the right amount ducktape (2x around the unit) for thickness, I used gorilla in the end it worked out just fine it never popped out again and tangled with seat belt.

 

[Tucson4runner]

I'll take it. I'll PM you for details

Sent from my SM-N950U using Tapatalk

 

[California4runner]

:bump:

 

[California4runner]

Still available

:bump:

 

[California4runner]

:bump:

 

[California4runner]

:bump:

 

[California4runner]

:bump: