Medic Endlinks

[tucktuck8]

So i followed all the instructions on adjustable end links from toyota120. I have the 1/2 inch all thread rod. I picked up some energy suspension bushings from my local autopart store. The interior diameter of the bushings is 3/8 and is too small to fit over the 1/2 inch all thread rod. As far as my research has taken me the moog thermoplastic bushings that are recommended are 3/8 diameter too. Where can I find bushings with the same collar size that are 1/2 or 9/16 interior diameter to fit around the all thread rod?

This is the link Im talking about: HERE

Any help from people who have done this mod?

 

[NuclearN8]

So i followed all the instructions on adjustable end links from toyota120. I have the 1/2 inch all thread rod. I picked up some energy suspension bushings from my local autopart store. The interior diameter of the bushings is 3/8 and is too small to fit over the 1/2 inch all thread rod. As far as my research has taken me the moog thermoplastic bushings that are recommended are 3/8 diameter too. Where can I find bushings with the same collar size that are 1/2 or 9/16 interior diameter to fit around the all thread rod?

This is the link Im talking about: HERE

Any help from people who have done this mod?

post #53 is a list of parts needed to create the heim style endlinks
Custom(ish) Extended Rear Sway Bar Links Write-up - Page 3 - Toyota 120 Platforms Forum

 

[tucktuck8]

I was going with a different style build. That build uses the 3/8" threaded rod which will fit the bushings but the one im using is 1/2" so it's not fitting.