multi terrain select not working

[[email protected]]

I replaced the front actuator yesterday and now the 4 wheel drive light flashes rapidly and the multiselect terrain indicator light is on and has knocked out that function....I have full function of the 4 wheel drive despite the light being on.... could I clear the lights by disconnecting the battery?

 

[Humble Leader]

probably damaged something during the install or forgot to plug something back in? check this thread, seems to the same or similar issue you are describing

Warning lights: Multi-terrain Seleft and Four-wheel Indicator lights flashing | Toyota 4Runner Forum [4Runners.com]

 

[[email protected]]

Thank you very much.... This sounds very likely that it is the issue!

 

[[email protected]]

probably damaged something during the install or forgot to plug something back in? check this thread, seems to the same or similar issue you are describing

Warning lights: Multi-terrain Seleft and Four-wheel Indicator lights flashing | Toyota 4Runner Forum [4Runners.com]

So... With the dash lights still flashing I went into a snowed in driveway and pushed my way through deep snow.... after I visited for a while I started back up and all lights were off and everything fully operational....I had things checked out after the weekend and there was a loose wire ,the snow must have put it back in place.... all secure and good now!

 

[Humble Leader]

So... With the dash lights still flashing I went into a snowed in driveway and pushed my way through deep snow.... after I visited for a while I started back up and all lights were off and everything fully operational....I had things checked out after the weekend and there was a loose wire ,the snow must have put it back in place.... all secure and good now!

a win is a win. user error (most likely) and not a costly repair