woodcutter500
New member
Hello all,
New to this forum, and I've searched for the same problem and saw a similar recent one, but thought I'd add a little more. Maybe it will help him out, too.
I have a '98 V-6 auto, ADD, Limited (more of my wife's car) with 225,000 miles. It's been a great vehicle, but all of a sudden this morning, I can't engage 4wd. I drove it the past few days in 4wd, and we've never had any problems in it's entire history.
Selecting the 4wd switch, I don't hear the normal clink/clunck (in the transfer case?) and no light on the dash. Only rear wheels spin on the ice/snow. Tried everything - in gear, moving, stopped, neutral, 4LO, turning, driving straight, driving backwards. 20amp 4wd fuse is fine. It isn't any colder than previous days, but I took it out for a 10 mile drive to warm everything up, but still no luck. I crawled under, and everything seems to be in place.
I changed all of the fluids in the car this past fall front to rear. I'm very good mechanically and a somewhat electrically. I do all of the maintenance on our 3 vehicles. So where to start?
Is the normal clink I've heard in the past the actuator, or the ADD up front? If everything is silent, should I assume that the actuator is not getting a signal, or could have failed? Could I put a meter on the terminals of the transfer actuator? If so, what should I read there? Same for ADD, maybe.
Help would be appreciated. The car is at the bottom of the hill down in front of the house until the ice melts and they're predicting another round of snow early next week.
Thanks.
New to this forum, and I've searched for the same problem and saw a similar recent one, but thought I'd add a little more. Maybe it will help him out, too.
I have a '98 V-6 auto, ADD, Limited (more of my wife's car) with 225,000 miles. It's been a great vehicle, but all of a sudden this morning, I can't engage 4wd. I drove it the past few days in 4wd, and we've never had any problems in it's entire history.
Selecting the 4wd switch, I don't hear the normal clink/clunck (in the transfer case?) and no light on the dash. Only rear wheels spin on the ice/snow. Tried everything - in gear, moving, stopped, neutral, 4LO, turning, driving straight, driving backwards. 20amp 4wd fuse is fine. It isn't any colder than previous days, but I took it out for a 10 mile drive to warm everything up, but still no luck. I crawled under, and everything seems to be in place.
I changed all of the fluids in the car this past fall front to rear. I'm very good mechanically and a somewhat electrically. I do all of the maintenance on our 3 vehicles. So where to start?
Is the normal clink I've heard in the past the actuator, or the ADD up front? If everything is silent, should I assume that the actuator is not getting a signal, or could have failed? Could I put a meter on the terminals of the transfer actuator? If so, what should I read there? Same for ADD, maybe.
Help would be appreciated. The car is at the bottom of the hill down in front of the house until the ice melts and they're predicting another round of snow early next week.
Thanks.