JustSomeName
New member
Hey everyone, I just installed my icon coilovers and seem to have some trouble adjusting them.
First, I installed both front coilovers and matched the number of threads on each side, thinking it would be the same length if the threads matched.
I put everything on and then drove around around my neighborhood a bit (a couple miles).
I then went home to measure each side and the driver side was about 3/4-1 inch shorter. So I rotated the driver side four of five times around and its still shorter.
The instructions say that I shouldn't reveal more than 2 inches of the coilover between the ring and the top and I'm pushing 2 inches on the driver side and it's still not even, does anyone have any suggestions or a reason why the threads are the same on both sides yet they still dont match?
First, I installed both front coilovers and matched the number of threads on each side, thinking it would be the same length if the threads matched.
I put everything on and then drove around around my neighborhood a bit (a couple miles).
I then went home to measure each side and the driver side was about 3/4-1 inch shorter. So I rotated the driver side four of five times around and its still shorter.
The instructions say that I shouldn't reveal more than 2 inches of the coilover between the ring and the top and I'm pushing 2 inches on the driver side and it's still not even, does anyone have any suggestions or a reason why the threads are the same on both sides yet they still dont match?
Last edited:
