Question about spring lift

[Atreyus]

Right now I have a 2.5 day star spacer lift, If I were to get these springs

Rear OME 891 Coils (96-02 4Run) - Toytec Lifts: Toyota Lift Kits: FJ Cruiser Lift Kits, Tacoma Lift Kits, Tundra Lift Kits, 4 Runner Lift Kits, Sequoia Lift Kits, Toyota Truck Lift Kits

would I have to take the spacer lift out because this is a 3" spring lift? or do I leave the spacer in with this new spring? Right now I'm currently on stock springs.

 

[WrexHAmm]

You would take the spacer out. If you ran the spacer on top of the OME coils you would have a huge rake.

 

[Gerdo]

X2
You will probably get more than 3" of lift out of those coils when first installed, they will settle a little.

You are also going from an old coil so you will probably get over an inch of lift.

Measure BEFORE and after (and write the measurement down in your owners manual). Measure from the center of the wheel hub to the wheel lip. This measurement is altered by suspension and body lifts only. This way if you change tires, or they wear down, it will not change your measurements.

 

[Atreyus]

Alright this will be the next thing on my todo list lol. Would 2.5in spacer in the front and those coils in the rear 3" look weird? Anynone know? .5 in difference?

 

[vr4boy]

Alright this will be the next thing on my todo list lol. Would 2.5in spacer in the front and those coils in the rear 3" look weird? Anynone know? .5 in difference?

hi,
just finished my install yesterday w/ daystar front lift(2.5) and 4 month old OME 891 in the rear...truck sits levelled as i was expecting a slight rake...the combo is perfect in my book

try to post a pic...

going for an alignmnet today