Rear axle seals, once again.

[shawnstcyr]

Tomorrow I am going to install a rear axle seal, again. This will be the 3rd one in a year and a half. I paid some shop to do it while I was out of state. The breather is not clogged.
I am going to perform an inspection on the bearing while I am in there. Perhaps run a little sand paper over the spot where the seal contacts the axle. After that, if this persists, it may be time to just change the damn axle. This time it will be a Toyota seal. Hope it works this time! :bash:

 

[Elton H]

i try and clean out my diff breather at least once a year