removing valance from front bumper

[ASUMTNEER]

I'm helping a buddy of mine replace his damaged front bumper on his 2003 sr5. The new bumper arrived painted and ready, but it looks like we'll need to remove his existing valance and place it on the new bumper. Are there clips like the 5th gen TRD Pro/TRDOR valances? I'd like to have all parts on hand if I could.

FYI, I searched and didn't see anything.

 

[Syr4RinNC]

Yea - I think it’s a few clips and a couple of small screws

 

[ASUMTNEER]

I removed this front valance Saturday and thought I'd update post for future reference. The valance is held on with 5 10mm nuts and the plastic tabs on the valance slide into corresponding open slots in the bumper. We replaced the whole bumper and bought a new valance since the old one got damaged. The only issue we found was some of the nuts were rusted and just turned the whole bolt, so we couldn't reuse them.

 

[Syr4RinNC]

Sounds about right