LawnDart
Senior Member
As some of you might have seen last week I have been trying to solve a problem of mounting a fire extinguisher inside the cab of the 4Runner where it can be accessed by the driver within a few seconds. The only logical spot is the tried and tested spot of behind your calves.
Unfortunately the only way to do this is to utilize the hard points offered by the bolts that hold the front seat rails down.
What this gives you is a sturdy mounting platform designed to hold a large fire extinguisher in place safely without effecting the use of the seat.
If you're particularly short in height you may be limited in exactly how far you can move the seat, but I found no issues with anyone below 5'6".
It installs within minutes, just requiring the foot caps to be removed, taking the bolts out, slipping the plate over, and reinstalling/retorquing back to factory values. The plate can also be drilled out for attaching whatever else you want. It will also work on both sides, and is universal. The plastic foot caps WILL still work but you will need to dremel out some clearances in the front to notch them.
These will be offered in anodized black, and anodizing will cost me 50 dollars for a batch. So if we make 10, it'll be 5 dollars. Price will be 50 dollars + shipping.
So basically I'm going to make at least 1-2 of these (2 for me), and I want to know who'd actually want one (or 2, your call) so we could gauge interest. I'm not going to start selling these so it's likely a limited run for now.
Unfortunately the only way to do this is to utilize the hard points offered by the bolts that hold the front seat rails down.
What this gives you is a sturdy mounting platform designed to hold a large fire extinguisher in place safely without effecting the use of the seat.
If you're particularly short in height you may be limited in exactly how far you can move the seat, but I found no issues with anyone below 5'6".
It installs within minutes, just requiring the foot caps to be removed, taking the bolts out, slipping the plate over, and reinstalling/retorquing back to factory values. The plate can also be drilled out for attaching whatever else you want. It will also work on both sides, and is universal. The plastic foot caps WILL still work but you will need to dremel out some clearances in the front to notch them.
These will be offered in anodized black, and anodizing will cost me 50 dollars for a batch. So if we make 10, it'll be 5 dollars. Price will be 50 dollars + shipping.
So basically I'm going to make at least 1-2 of these (2 for me), and I want to know who'd actually want one (or 2, your call) so we could gauge interest. I'm not going to start selling these so it's likely a limited run for now.
Last edited: