MagnumCutter
New member
Rear Differential Skid Plate from RCI Metalworks
fits 2010-Present 5th gen T4R (non-KDSS)
Asking $225+shipping
Powder coated, CNC cut and brake formed from 3/16″ steel plate. was $295 new. This was never installed because it didn’t fit my KDSS equipped vehicle. Minor surface scratches from sitting in the shop but otherwise in almost new condition.
Rear Differential Skid Plate | 10-Present 4Runner – RCI Off Road
**WILL NOT FIT KDSS MODEL**
KEY FEATURES
* Protects the low hanging rear differential
* Clamps directly to axle housing for an easy no drill install
* Hugs differential tightly, within 1/4″ for minimal loss in ground clearance.
* Black powder coated for rust resistant, durable and high quality finish
* Design incorporates drain holes for water and dirt to escape, as well as allow full access to the differential drain plug
* Installs in minutes
* All hardware and installation instructions provided
* Direct bolt on addition to existing factory attachment points, no drilling required
fits 2010-Present 5th gen T4R (non-KDSS)
Asking $225+shipping
Powder coated, CNC cut and brake formed from 3/16″ steel plate. was $295 new. This was never installed because it didn’t fit my KDSS equipped vehicle. Minor surface scratches from sitting in the shop but otherwise in almost new condition.
Rear Differential Skid Plate | 10-Present 4Runner – RCI Off Road
**WILL NOT FIT KDSS MODEL**
KEY FEATURES
* Protects the low hanging rear differential
* Clamps directly to axle housing for an easy no drill install
* Hugs differential tightly, within 1/4″ for minimal loss in ground clearance.
* Black powder coated for rust resistant, durable and high quality finish
* Design incorporates drain holes for water and dirt to escape, as well as allow full access to the differential drain plug
* Installs in minutes
* All hardware and installation instructions provided
* Direct bolt on addition to existing factory attachment points, no drilling required
Attachments
Last edited:
