TC rep says to grease the bushings on the upper control arm every time you get an oil change (guessing every 10Kish miles) but I haven't had any problems since I've installed them about 1.5 years ago (bushings have the same form/size, no squeaks, and still can see grease around the bushings.) Does anyone here have the same experience where they don't seem to have to grease the UCA's bushings?
Total Chaos UCA
- Thread starter rnguyen95
- Start date
Register to hide this ad
Bigrupp
New member
Do you wheel much? When I spend more time on the trails mine tend to spit more grease out and I'll clean them up and grease them more often. If I don't hit the trails I don't have an issue and could probably go a lot longer without messing with them.
Sent from my SM-G955U using Tapatalk
FactoryRide
New member
I grease mine every couple of months. Make sure you loosen the bolt before you add the grease! If not, the grease doesn't have anywhere to go.
http://chaosfab.com/PDF/install/accessories/69000.pdf
http://chaosfab.com/PDF/install/accessories/69000.pdf
gm350reratliff
New member
I use this stuff on everything that has a urethane bushing: Prothane 19-1751 Super Grease Tube - 14 oz. https://www.amazon.com/dp/B004JMEC0E/ref=cm_sw_r_cp_tai_zcQBAbJZWVAQE
It’s very thick but seems to lube very good and is waterproof. Get a heavy duty grease gun for it.
Not to stray off topic, but please don’t tell me you change your oil every 10k miles [emoji45]
Sent from my iPhone using Tapatalk
