rfe1dotcom
New member
Greetings Toyota Aficionado's!
I have a BMW/Mercedes shop in Scottsdale, AZ and I have to confess I have never worked on Toyota's...My daughter decided to buy a used 4 runner off eBay that matched her exact color combination and specs - and she did. The 2003 Limited 4 runner V8 came in on a carrier looking pretty. It started right up, drove fine. She put about 250 miles on it when she noticed a little hesitation. Put another 20 miles on it and the check engine light started flashing. She brought it to "daddy's shop". My first diagnostic showed a P0310 missfire in Cylinder 1. I went the easy way, new plugs and coils and re-set. Instant check engine light again - flashing, car runs rough, but runs and drives if needed...Pressure test - Cylinder 1, maybe barely pushing 20 - 30 Psi...Everything else healthy pressure. Car has 93 K miles on it, dealer maintenance including timing belt at 91K. No white smoke, no contamination of oil...What do you guys suggest at this point? Stuck/Bent valve? I don't want to swap engines because this one is not that sick in my opinion...Any input greatly appreciated!
I have a BMW/Mercedes shop in Scottsdale, AZ and I have to confess I have never worked on Toyota's...My daughter decided to buy a used 4 runner off eBay that matched her exact color combination and specs - and she did. The 2003 Limited 4 runner V8 came in on a carrier looking pretty. It started right up, drove fine. She put about 250 miles on it when she noticed a little hesitation. Put another 20 miles on it and the check engine light started flashing. She brought it to "daddy's shop". My first diagnostic showed a P0310 missfire in Cylinder 1. I went the easy way, new plugs and coils and re-set. Instant check engine light again - flashing, car runs rough, but runs and drives if needed...Pressure test - Cylinder 1, maybe barely pushing 20 - 30 Psi...Everything else healthy pressure. Car has 93 K miles on it, dealer maintenance including timing belt at 91K. No white smoke, no contamination of oil...What do you guys suggest at this point? Stuck/Bent valve? I don't want to swap engines because this one is not that sick in my opinion...Any input greatly appreciated!