what size coils for zuk mod

[ncgyver]

I have an 87 Stock T4R ready for a zuk mod. What size coils for a non welding mod would work best ? Gonna do it as I change out my shocks.

 

[KidVermicious]

How much lift do you want?

 

[ncgyver]

I just want Soften the jolt and take the sag out .

 

[ToyoTech]

i used rear coil from a 96-98 4runner. it was no weld or cut install.
took care of the sag and gave me a lift too. you can cut the spring down to just take care of the sag. if you keep it stock height, i would get some factory or replacement shocks. if you dont cut the coil and enjoy the lift it gives, look at getting some OME shocks

 

[KidVermicious]

I just want Soften the jolt and take the sag out .

I used a 125 lb 14inch coil and it gave me about 2 inches over stock. If you're just looking to get back to stock height, I'd use a 12in 100lb coil. They're about $30 each from Southwest Speed on Ebay.

 

[ncgyver]

Ok Thats what I was looking for. I have to haul my water to the house so I either pull a trailer or I have a 35 gallon tank in a hitch basket. It bottoms out on the bump stop as is. I'm looking at Putting on Rough Country shocks on all fours and doing the zuk mod. very Soon.

 

[4runnerBrett]

Too bad your not closer I have some 13 inch land ctuiser coils that would probably work awesome.

 

[ncgyver]

Would you ship them?

 

[crazy gringo]

Go to WWW. gearinstalls.COM scroll down to bottom left hand side of page there is where you will find the zuk mod listings. I used the 12" 100 springs and NOW IT SITS 1.5 INCHES ABOVE STOCK HIGHT SO I ORDERED BALL JOINT SPACERS TO LEVEL IT OUT AND i love the ride now. It also has video of how to do it

 

[RAD4Runner]

I used a 125 lb 14inch coil and it gave me about 2 inches over stock. If you're just looking to get back to stock height, I'd use a 12in 100lb coil. They're about $30 each from Southwest Speed on Ebay.

Did same (actually 125-pound 12-inch springs) with no noticeable rake here.

 

[crazy gringo]

yep your right 12" 125 springs my bad