Prev
Sweet shot of the back of the alternator. I was able to use the "bend and drill" technique in Doc's CS144 thread to reuse the stock connector and plas
Next
Prev
Closeup of the alternator, engine block ground (goes directly to battery negative terminal), and the power steering pump belt used in place of the fac
Alternator is all in! I did have to remove all the drive belts, so the job took about twice as long. But worth it for sure.
The copper wire lugs after soldering and hammer crimping them, but before heat shrink. The hammer crimper was easy to use and creates very strong conn
Sweet shot of the back of the alternator. I was able to use the "bend and drill" technique in Doc's CS144 thread to reuse the stock connector and plas
The "original" (not OEM, PO put this on here unfortunately) ground wire. The little tiny wire from the negative terminal to the chassis was also almos
The other two wires that I connected to the positive battery terminal. The larger ring terminal is the original power wire, and the smaller 10-gauge w
My first complete 1/0 cable is made. For the copper lugs, I melted solder in each of the lugs (filling the lug up with small-ish pieces caused the mel
Next
Toast

Sweet shot of the back of the alternator. I was able to use the "bend and drill" technique in Doc's CS144 thread to reuse the stock connector and plas

  • Media owner Toast
  • Date added
There are no comments to display.

Media information

Album
'97 4x4 Progress
Added by
Toast
Date added
View count
0
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Members online

No members online now.
Total: 3,410 (members: 2, guests: 3,408)

Forum statistics

Threads
278,315
Messages
3,554,130
Members
248,016
Latest member
Advally Service

Share this page

Back
Top