Prev
You can Ziptie and tape the bubble wrap over the lense to protect it while you assemble the headlight, also you can stick the bulbs in to keep dust pa
Next
Prev
after mounting the projector I attached the reflector, without the glass back onto the mount.
After I drilled the holes in the reflector I mounted it, I used 6 32 2" screws When I take it apart again Im going to use some nicer m4 cap nut screws
The two white plastic pieces adjust the angle of the headlamps. In my opinion you should align you projector coaxially with the bore of the thing stic
You can Ziptie and tape the bubble wrap over the lense to protect it while you assemble the headlight, also you can stick the bulbs in to keep dust pa
I put blue tape over the glue on the edge so the plastic dust wouldnt get into it.
Dremeled out the back of the reflector.
Reflector with glass and center piece removed I used a heat gun on edge and a razor blade then a wide chisel to pry it open, Sort of a pain but Once
Next
D Farms

You can Ziptie and tape the bubble wrap over the lense to protect it while you assemble the headlight, also you can stick the bulbs in to keep dust pa

  • Media owner D Farms
  • Date added
There are no comments to display.

Media information

Album
3rd Gen FXR-3.0 Retrofit
Added by
D Farms
Date added
View count
0
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Members online

No members online now.
Total: 3,389 (members: 2, guests: 3,387)

Forum statistics

Threads
278,315
Messages
3,554,130
Members
248,016
Latest member
Advally Service

Share this page

Back
Top