Recent content by 02 Black

The trans will shift from 1st into Reverse and 1st into 2nd but nothing higher. It isnt throwing what appears to be any codes but the O/D OFF light is continuously flashing when the 2 diagnostic points are jumped. I pulled all 3 solenoids and tested them with 12v and they seem to work...

Are they the same or would I restrict flow if installed on a 3.slow? Good rhyme right???

Update I swapped in a new 02 sensor, egr modulator, egr valve and the truck now smells far better but it still does not want to rev past 3k, what could be causing this?

Hey whatsup guys the previous owner said he swapped in a tacoma trans., the problem is that I cannot determine the model as there is no id plate. Also the trans does not want to shift past 2nd gear, how can I figure out the model, so far all I have found is 3V marked on the bottom of the case...

I should do the sucking test on the top smaller hose from the EGR valve? What exactly should I be watching for while performing felacio? Thx 02 Out

Hey whatsup guys, my 93 melted the egr vacuum modulator after replacing all vacuum lines, and has code 25(lean air/fuel mixture). It will not rev past 3000-4000 rpm, idle is fine, exhaust smells like it will likely not pass smog, the last egr vacuum modulator melted at 3000rpm after ~20sec...

UPDATE*** I just spoke with the previous owner and it has a tacoma transmission installed ~140k ago

UPDATE****** she is throwing code 25

Hey whatsup guys I recently picked up a 93 automatic T4R off my buddy, its got quite a few problems. To start, it will religiously not rev past 4,000rpm but usually it wont pass 3,500rpm, and if I hold the throttle there it starts to sound similar to hitting the rev limiter, the valves were...

A friend of mine was telling me how he runs racing pistons and cams on his 2000 Tacoma with gains of 70 hp, and the pistons and cams have a 5 year warranty( i dont recall the brand ) is this true? Has anyone installed these? Im try to find something cheaper than a supercharger but with more...

I stripped out my R&P a while back and I'm finally taking it to Pro Gear Differential in San Diego, has anyone used them before or know anything about them? I'm not sure on the price yet but hes going to open it up and give me a full quote with no surprises. I've got a 2002 2wd Automatic Sport...

I wrote down my VIN today and how can I tell what you what my ratio is? I remember there were two different ratios,and the specific ratio had to do with what the VIN ended in. I stripped my Ring and pinion and I'm planning on getting the same R&P with a diff so I can just drop it in with the...

I drove it back to my house which was a few hundred feet away, and it sounded like a train going only going 20, at the same moment every time my back end would bounce when the stripped gears hit Right now im running 33 Grapplers, what is the stock gearing, and what would be the right gearing...

One of my buddys has a 2010 Taco and hes got a mesh grill, on the new tacomas the stock plastic grill pops out and you can screw in the mesh to the outlining grill, I've only heard of the DIY mesh grill for 4runners. Have any of you guys heard of any bolt on mesh grills, also I was hoping to...