Recent content by 1990silverbullet

Hey, afternoon. I'm in need of some help. I replace my timing belt and water pump and it went well but after about a month it started spraying anti freeze on the bottom of the hood and it started peeling paint. it was also overheating after a couple mins of driving. Would this be a symptom of a...

So I haven't posted her for awhile. My 4runner was resting while I got some time to work on her. I started my timing belt and it seems the one of the bolt holes for the water pump is stripped out. What could I do to fix it do I have to re tapp it or is there a little sleeve I could get? Any help...

Im back and need a little help Hey there everyone. I have not drove my runner in a little a couple months and she needs some love again. I haven't had time to drive her because of my work hours and I live in a bigger city so I drive my car for better gas mileage. I finally have time to take my...

So does she still shake??

Have you cleaned your throttle body. If not I would start there. After I cleaned my throttle body and replaced some vacuum hoses my truck went from a 2100 idle to about 1200 and the gas has improved slightly. Im with you though if I had money I swap a 3.4 into her. I'd think about getting a...

Thanks dude!! As for the shake, I've read your thread just don't remember and don't wanna go back, have you replace the bushing between the body and frame?

So this weekend if I have time im going to take the whole throttle body off and deep clean it really good. After I put it back on and ill mess with the idle down and clean the EGR. Thanks for the ideas ill let you know if it fixed anything.

So I've developed a high idle. On Cold mornings it idles at 2100 cold then at about 1700 warm. I Cleaned my throttle body and now it idles at 1500 cold and 1200 warm. I also replaced a lot of the vacuum hoses from a kit I got from LCE. Is this normal? what does every one else's truck idle at?

Hey I've been following your thread and good job. Have you looked at your rotors? I know it sounds dumb but when I got my runner mine shook just like yours. I took the front end apart and greased it just to make sure the front end didn't need new parts. It does to this day, like lower bj and tie...

Well... Im getting a little worse than you guys. I'm sitting at about 170 Miles per tank. Im Kinda tired of spending so much for gas(at about 50$ a tank). Even after the vacuum kit install.

Heck yea dude. Cant wait to see it.

On My Truck the PO had some subs. and it looks like he went through the passenger side. I haven't really looked into it yet but I can probably find out where he routed it if you would like. Honestly If you already have a hole in the fire wall for your hella lights I would just run it though with...

Same thing is happening to me... Only thing that is weird is that I Replaced all my vacuum hoses with a kit from LCE Engineering and still the problem persists... Im at a loss as well.

So I noticed my shifting was getting a little crunchy. I could hardly get it into reverse or 5th.I saw a thread on yotatech about replacing the shifter seat and cap. I ordered the shifter seat and cap it was only like 10$ from Toyota. I was surprised on how good it shifted after I saw the...

Update: Shes gone. I Got abunch of parts then realized I have no time to fix it so I sold it to someone as is for 500$. Sucks I had to part with her but at least I still have my grey runner.