Recent content by 4RunnerChaos

If that 4runner has a better condition frame I may look into it as an option, as for COB I have someone who pretty regularly drives to and from Arizona and sometimes to California doing transport stuff so I actually might be able to talk to you about some stuff :)

Well, I knew how bad it was, I was just seeing if the guy was THAT good. That would most likely end up being what happens. But I will need a daily in that case.

Definitely will! I'll shoot you an friend request and stuff on here. If I do frame swap, I'd be going with a lift, and motor swap(possibly) buy idk yet, need to figure some things out. And see how long it lasts as it is. The frame wasn't this bad but over the past two months it has deteriorated...

The top of the crossmember runs all the way up the right side of the frame and that section is still fairly strong, which is where the one year number is coming from. If that wasn't there I'd be at the lot looking at trucks right now.

It has pics now :) Updated with pics.

I'm half tempted to spend a week driving there and back to get it from you :p

I have very seriously considered a frame swap. But that involved transferring EVERYTHING over which could be a PITA And yes I know it is useless. I shall go snapshot while I reinstall my driveshaft

Well, stopped by a shop to have my rust situation checked out.... And was pretty much told that it's beyond repair and has about a year to live.... On the driver sidr the rust reaches from the body mount forward of the crossmember to about 4 feet back. And about 90% of the bottom is rusted...

Drove 430 miles on 1-3/4 tank today. So shush about your not hitting 300 a tank! Just kidding its really been bothering me how poor mileage I'm getting though, I don't think one of my cylinders is firing properly or burning all the fuel. And it probay didn't help I drove in 4 wheel drive (rear...

Well if its any consolation I pulled my driveshaft (about 30 minutes work with hand tools) $17 U-Joint $40 labor and now its sitting in my garage to be put back on tomorrow. When. This problem first arose I could NOT get any strange movement, and even after three of the bearings almost...

Reading this article whilst in a motor vehicle. :D football field following distance though... I find it incredible how that rig is damaged... It looks to be mostly body damage. I would indirect measure and have someone experienced check on the frame front to rear and make sure everything is...

Hey I have this same problem and posted a thread a while back and most everyone pointed at the drive shaft. I have not gotten down to solving the problem but if u may suggest, get it fixed because it only gets worse lol.

I have a great deal for some 17" wheels off of a 2016 4runner and was wondering if they would still fit the third gens?

Not mine. The intention of this vehicle originally was to have a receiver installed for pulling around snowmobiles but then said snowmobiles were sold... I would raid the local yard to find one but the fort problem is finding a 4runmer in the junk yard.. Second would be removing it due to the...

So my question is about using a 1998 tacoma rear bumper on my 1998 4runner limited. Do they fit????? Just curious... I'm looking to use a cheap junk bumper in order to pull small loads, not looking on spending too terribly much and if I could get away with something else I wouldn't mind any...