Recent content by Bucket81

I didn't really want to go down the custom wheel rabbit hole. I'd like to get the FJ wheels I found but the offset just isn't right.

I actually just ordered some JBA UCA! I had it in for an alignment and it looks like one is bent so I figured I'd order some and see if they give me more clearance. I wish those FJ wheels weren't 8in wide...

I just installed a lift and headed over to Discount for a new set of tires. I wanted to go bigger currently I am running the factory wheels with 265/75 16x7 I think they have a 15mm offset. I was planning on putting a set of Sequoia 17x7.5 with a 15MM offset which would tuck a bit more. The guys...

Are these the ones? OME95PF5 - OME Trim Packer I'll have to see about stepping up the bumper timeline. I'm sure I could find something heavy to put in the back. I also found these. They go on top of the tophat. Suspension Trim Packer - YotaMafia

So I installed a lift. Bilstein 5100 front and rear OME 881 in front OME 890 in rear And this thing is raked out like a dragster. Passenger front 36 1/4 Driver front 35 1/2 Passenger rear 39 Driver rear 38 1/4 I'd like to level it all out and It was suggested that I put in 5mm top plate...

Yeah... I did and took it apart not paying attention.... I'm going to pay for that later.

My top hat is different then the one in the video, mine has rubber protruding from the bottom like the bushing, and the one in the video goes straight to metal.

Thanks! I got one from the dealer.... it doesn't fit.

Those are for the rear. I need the front bushings. Thanks thought.

Does anybody have the part number or a place to buy the rubber bushings on the top of the shocks? I got some 5100 and didn't realize they didn't come with them.

Back Story - A few years back, I'd have a clunking noise in the morning when I'd back up and leave for work. After multiple mechanics, one figured out that it was the cam alignment adjustment causing the issue. It was tight but had movement. So.. Air chisel some metal. From what I am looking...

I haven't seen any water in the oil or the AT fluid. I think some one mixed red and green....

I did, I ran 3 bottles of the stuff. Usually ran them for a week each. Yeah, I am getting about 2 gallons each time. I'll see if I can find that block drain next time I drain it.

I purchased a new Denso radiator, and I was planning on flushing the old system before installing the new radiator. But I can't seem to get the system clean. I have ran distilled water through it multiple times, and the coolant comes out black. I've gone through about 10 gallons of water. This...

Devbot wtfemery Thanks I'm interested in what the Embark specifically will look like on a 3rd gen.