Recent content by coreymclaren93

bump! finally fixed it!, I flattened the top of the mount where the 3 bolts threaded in. put a half inch thick peice of steel under the mount. and threaded bolts in with nuts on the bottom!

I can push it down all the way, but it doesnt come back up by itself, and its hard as hell to pull it back up:shrug:

Hey I was in working on the front end and noticed my front shocks looks like they might be a little compressed? they barely move when going over rough stuff and it feels like your getting a massage when riding on dirt roads, should I get smaller ones? so the spring can be used as its supposed to...

THANKS! for all the quick reply's! Love this site! I'm trying to find a similiar product online but cant seem to find any? I think it does lower it down a bit! cause I have 35's and theres not a whole lot of room compared to my buddy's trucks, I was going to downsize to 33's but now i'm thinking...

Hey guys I bought a new rig it has a 6" lc lift in the back and not sure about the front, it seems to have this weird body lift I guess you can call it? It lowers the front end down alot I find..?

im dont know!!! hey, yeah I thought that! but the engine mount bracket taht you can buy doesnt come with the peice to hold the control arm down?

Alright, this is what I have to show you for now... definately a little confusing, #1 is the side engine mount on the left side of the vehicle. #2 is the bracket that where the three bolts that hold down you upper control arm is.The single bolt on the front took the nut with it... the 2 that...

no ideas anyone????

Hello there! I'm very new to the forums and the 4runner scene, I bought a 1990 4runner with a 6" lc lift and a very messed front end. the three bolts that fasten down the upper control arm on my drivers side have lifted, and jammed against my steering rod, This is the second time this has...

new problem! thanks for the quick responses guys! I jacked it up, took off the wheel, and noticed that the 1 of the 3 bolts that are securing the a-arm to the frame is backing out, ( about a week ago I had the a-arm mount snap and I re-welded it all and tapped the nuts under, , it held fine at...

Was thinking about that! I'm not really wanting to remove the a-arm, had enough troubles getting it sucured on there after the mount had snapped off from before, but was thinking about loosening the front torsion bar bolts going into the a-arm? just dont want the bar to twist to much cause I...

Hey there everyone, this is my first post on the forums, I bought an 1990 4runner, 6" lc lift, 35's etc. first got it, took it wheeling the front torsion bar mount snapped and locked my steering, fixed that, but when i re-attached the torsion bar I had it to low, the truck was leaning to one...