Recent content by hawee99

Complete. I think it sits pretty good. Might be kind of hard to tell because the driveway is a bit angled, but I don't think the front is up too high what do y'all think

Nevermind. I just looked at it again with a fresh set of eyes and I think it makes sense. I don't see any way to delete a post on here. But I will take a picture of the order once I get around to it in case anybody else has the question later on

I'm a little confused on the order of the bushings for these rear 5100s. My hardware kit has two different styles of bushings. And from what I can tell from a few installation videos I found, the two bushings should be the same. both with a slight edge on them, like the screen shot attached...

I got the fronts installed today and it seems like I've gained 3". I think I understand that excess can be due to the potential sagging OEM parts. I'll get the rear done tomorrow and asses. Thank you for your response also, I did the no compress method. Easy peazy

No apology, thanks for your reply! I almost went down the wheel rabbit hole and just decided to say F-it and bought TRD Pro Wheels. which I think might be similar to the FJ wheels. So your input is helpful. I think the 255/75 is gonna be awesome

Hello, I'm starting to second guess myself. My plan is/was to install 5100 in front at the 2.5 setting. And reuse the stock coils. They only have 40k on them. I will also install 5100 on the rear and add the 895e OME coils that say will add 1" I have TRD pro wheels on the way. 17x7 with...

I mean, I have a 10.5" on 15x8 on my Jeep and it looks good. The 255s are basically 10"

Does anyone else have an opinion on how the 255/75 will look on an 8" wide wheel. Aftermarket 7" with 0 offset is tough

I'm not seeing a photo for some reason. Yea, the main reason I said 8" is because I'm not seeing too many options of 7". I would love a TRD wheel of sorts. I think there might be an FJC wheel at zero offset. Comes at a cost though. If anyone knows of a 17x7 or 7.5 wheel with a 0 or less...

Hello, I'm hoping that anyone who has experience with this tire size can give me some input on the best offset wheel. I would like it to be flush with the fenders. I am most likely going to get duratracs and most likely a 17x8. I believe the factory wheel is a +30 on my 2003 sr5. Thanks...

I recently installed a pioneer as well. I used a CRUX harness to integrate it with the factory JBL amp. However it sounds BAD. I'm now reading some information about this process and it's telling me I needed to adjust the factory head unit setting in a particular way before I removed it. I'm...

Hello, I'm trying to gather all the parts that I need for a 3/2" lift on a 2003 sr5. No reas or air shocks. The kits that I see our advertising fairly long lead times. And I'm hoping to start this project next week. I'll post some links For the rear I think $207 Old Man Emu 2895 Coil Spring...