Recent content by Justfuzzit

So I did exactly this, worked great (so far). Thanks! Super easy for anyone looking to do the same. You can probably do it without removing anything, but it's better for pre-cleaning. Here's some pics... Pop trim piece down and remove the nuts holding on the glass: Remove glass: - I used...

Adding a picture of the bezel crack... I think that whatever sealer is used, it needs to be injected well up into the crack and under the rubber. Otherwise it will just negate the sealer and leak on the sides. The water leaks through the crack, into the headliner and under the map lights. Then...

Searching, can't find answers. Please post them if I missed anything! 2000 Limited 3.4 V6 My issue... Starter is super labored sounding, slow like it's not getting enough power. Once it turns over, it's usually ok (now that I fixed the rubber bumper under the cable head at the gas pedal... it...

Hey guys, I got everything back in and it all works. I replaced most bulbs in my climate-control unit, and also in the control bar just above it (rear window, etc pwr, etc.). Only some were actually dead. I also cut the orange illumination wire on the aftermarket wiring harness. The clock is...

Hey, Has anyone had issues with tweeters not working? Hardware: - 2000 4Runner Limited - Alpine CDE-147BT Issue: - Tweeters don't work - Clock is dim, and air control LED backlight is not working Note: - Antenna secondary/booster not plugged in - Stock amp removed - Fuses checked My...

Edit: Re-Posting Here: http://www.toyota-4runner.org/3rd-gen-t4rs/124628-3rd-gen-stereo-head-unit-install-w-pics-7.html Hey, I can't find info on this by searching... So I'll ask! Hardware: - 2000 4Runner Limited - Alpine CDE-147BT Issue: - Tweeters don't work - Clock is dim, and air...

a Q-Tip with de-natured alcohol. Gently wipe the head vertically (going with the line in the middle) Shoot, gotta go to work. Hope that helps!

I think in your case it would just be a dirty head I would assume. There's probably a similar fix, yeah.

My deck has semi-recently started skipping near track 8,9,10 area on CD's. And once it starts, it won't stop no matter where you're at. And it's much worse when moving. I've heard of this problem seemingly after 2001? I have reason to believe this could be simply due to a dirty lens, but I...

You know, I was thinking I already did that, but never after I swapped the 02 sensors... We'll see if that changes anything, thanks!

Yeah, I've heard it one way and experienced it the other. I installed an intake on my old Explorer and the mileage jumped ~3mpg better. But I'm sure one car could react differently to the change.

Haha thanks. Yeah, you could be entirely correct. If I can't figure it out, I'll continue tracking my mileage and driving light (most of the time XD)

I did... How do you do that? My buddy cleared the check-engine code (for the 02 sensors... like 3 times until I replaced both), but I'll assume that's not the same thing XD

Worse gas mileage AFTER installing new Cold Air Intake, both O2 sensors, and rotating the tires... I was getting around 19-22, now getting 17-19 driving like a grandma, taking inside lines... Everyone says it's because the intake gave me more power, and so I'm driving harder, but I'm not! I'm...

Yeah, street only for sure. And if I do ever do any off-roading, I'll switch it back and do the deckplate mod. I had a K&N intake on my 96 Ford Explorer, and it made a significant enough difference. I never had any issues with the MAF sensor, given I oiled it correctly. The only potential...