Recent content by mamon77

I had a spring break on one of my hubs and can't find a used one so I've been asking around

my 4runner. So 4.88s it is. thanks for all the info and help!

fourwd1, Did search, nothing I typed in brought anyhing up about where to find the connector. Looked under the hood found 2 connectors stuck in rubber sockets/boots used paper clip across terminals no CEL flash no matter how I jumped them.

Would like to know where to find the port so I can see what codes my 4Runner is throwing. Went to autozone they said it was too old for them to check

thanks for the info. how much of a difference are the 4.88 gears going to make with my 33's compared to my stock gears? gas mileage, pick up, going up hills, ect??

well my son uses it to drive back and forth from school, 1 or 2 times on the highway a week, and the occasional trail ride every now and then :lookout: i would like to run 5.29s but ive heard they arent to well for highway use. for now i will stay with 33s but who know maybe i might run some 35s...

1985 4runner 22re standard 5 speed transmission 4x4 with 15 inch rims and 33 inch tires. wanting to know some input on what gears to upgrade to. i currently have the stock gearing and was wondering either to go with 4.88, 5.13, or 5.29. thanks :hello:

k Thanks

i am looking to buy rims and trying to make sure that 6x5.5 is the same as 6x139.7? i have a 1985 4WD 4runner. 139.7 mm converted into inches is 5.5 so will this work? thanks

? Is there an advantage of doing the battery, air-box switch over just putting in a K&N filter? Does it breath better being closer to the intake/

Hi, just trying to see if you guys would recommend putting a dual steering stabilizer on an 85 4Runner with 33x12.50x15's and also what shocks would be best for same truck with a 4" lift on it.

So drop the tank to get to the connections to clean them to see if its going to work? It was reading half full then I filled it up and it hasn't moved since. Thanks

Would it be wrong to run 20-50 n mine? Also have heard to run Rotella in them for its anti-weaing factors. Any thoughts?

Need to clean sending unit to see if the gauge will read correctly before I replace it. Is there an easy way to reach it or do I need to drop the tank. Thanks

I haven't checked the wire or pulled it out but I will do that before I buy anything. Do I have to drop the tank to get the sender out?