Recent content by Ron_Mexico

I’ve been seeing people showing their brand new 2025’s with bigger tires. I would like to move up from the stock 265/70/r18 to K03 275/70/R18. Is there anything I should be concerned with? Like warranty issues or if it’s too hard on transmission and do damage?? It appears that everyone posting...

Just thought I’d give you guys an update on these trouble codes. I ended up disconnecting the battery and cleaning the terminals/connection points. I cleared the codes and it has been almost a month and the trouble codes didn’t come back. Perhaps the computer wasn’t getting good voltage from the...

I have a 2006 V6 4WD Sport $runner. Here is a screen shot of my OBD2 results. Did anyone diagnose these codes, my check engine light came on today and this is what my OBD2 reader brings up. The P0038 and P0058 are after the first set of catalytic converters showing voltage transients. I don't...

Thank you !!

The dealership is closed on the weekend when I broke the piece. I was hoping somebody who is lurking on this forum would know so that way I can have an idea of how much this part is before calling the dealership. Yes I am planning on going into the dealership tomorrow in person to the parts...

I have a 2006 4Runner Sport V6 4WD. I can’t find the part number to this piece that looks like a heat shield protecting the propeller shaft where the 2 zerk fittings are on to lube it. Mine broke off due to rust when I was using the grease gun. The exhaust runs directly underneath it. I found...

Just a FYI update, I put in an OEM sensor and it didn’t clear the issue. I then replaced the front passenger wheel bearing and it cleared everything!! ABS system is fine. Looks like a shitty wheel bearing was throwing the trouble codes!! I’m so stoked and got new tires to mount!! Thank you...

I had to do a wheel bearing replacement and that cleared to ABS trouble codes finally!!! Thank you all for your help!!

I managed to clean the hole out with a dremel wire brush. The sensor fit it nice and easy. I have the connector plugged in and went for a drive. I figured the ABS light would reset and go away after some driving but it didn’t. I do have a code reader that reads/clears trouble codes, including...

Does anyone here have issues/difficulties replacing the ABS speed sensors on these vehicles? I removed the old one (had to drill it out). I used a wire bristle brush to clean out the cavity where you insert the new sensor but it is a very tight fit. My fingers hurt from all the pushing and...

LoL you’re right. I ordered an OEM sensor. I’m returning the Amazon junk sensor!!

I had the dial turned to ohms (200). I watched YouTube videos of people getting ohm readings to compare sensors. I tried the dial on ACV (200) and it just reads 0. I don’t understand these things!!

I tried to do this with a multimeter. I removed the connector from the sensor that I know is good (front left sensor). There are two connector wires in the sensor. I tried to touch each wire with the leads (1 red, 1 black) and nothing changes on the screen of the multimeter. When I touch the...

Sensor output?? What value should the sensor read? Thanks for the reply!!

Using a code reader I found 3 codes: C0200 Front Speed Sensor RH Circuit C1223 ABS Ccontrol system malfunction C1235 Foreign object attached on top of speed sensor I recently replaced this sensor. Doesn’t make sense. When I originally had issues with ABS system (brakes pulsing) I attempted...