Recent content by Ross

I am traveling and no Toyota dealership close.

I tried searching but the search function won't work on my tablet. What thermostat so people recommend for a 2004 4Runner V6?

I got the new cap from Toyota. The old cap was also Toyota and In bad shape when I replace it.

If i take off the overflo cap i can blow air out to the radiator side but not where it would flow out of the reservoir to the ground. Should I be able to blow air out that side through the overflow?

I have a 2004 4Runner with the V6. The overflow reservoir fills up but won't return coolant to the radiator. I have changed the cap but that didn't fix it. I will change the thermostat next. Is there anything else that could cause this?

It hasn't leaked since last night after retighten the stem. I am sure it will leak again. I am sure I will end up at them shop getting it replaced. I will just get a regular valve stem.

I already changed the Schrader valve and that didn't fix it. The valve cover case screws into a fitting that comes out of the rim (the sensor I would think). I was able to tighten that from the outside and that slowed the leak, I don't want to tighten it too much. What I am wanting to know...

I have seen campers much older than 10 years every place I have ever camped.

To replace the entire valve stem the tire has to come off enough to remove the sensor but I was wondering if I could unthread the stock valve case from the outside, rap some plumber tape around the threading and reinsert it to stop the leak.

can you replace the valve stem with just a regular rubber one, mine leaks? I have a 2004 4Runner

With one kayak yes but far from ideal. But in the OP it says kayaks. Unless they are skinny kayaks, you won't be able to fit them though the window and I would not carry anything with the rear door open. I would put them on the roof or get a trailer. I prefer a trailer.

I got a Hybrid a couple years back and I have been very happy with it. Mine weighs 2400 lbs empty and is easy to tow and set up.

I have a slow leak in my tire. I snugged up the valve stem housing and the leak got slower. I didn't want to tighten it too hard. I replaced the valve stem and that didn't help. My question is can I remove that valve stem housing and but some plumber tape on it to fix the seal without...

Thank you

I have found allot of info on the rear bumper cover but I am looking for info on removing the front bumper cover for my 04 sport. I would really appreciate it if anybody could post up a link.