Recent content by saabpowered

Not really sure where he was going with this lol

Thank you! Definitely will give him a shout.

How do you figure it's not an upgrade? Going to forged internals and a cast iron block, not to mention the turbos?

Not trying to sound like an *** but why wouldn't I be ready for a swap? Isn't the the point to ask the question in the process of starting the build? Now I've done a 2jz swap before.... Pretty confident I can do it my self if it will fit... More or less if it will fit I can make it happen...

Has anyone attempted this? Looking to do the swap myself so cost would be low but I am more or less worrying about the length of it. Any helpful advice would be great

I had a guy do this for the longest time. Asked politely to move his car never would. So got old Betsy fired up (1989 f350 diesel) and with in minutes car was moved and the owner got the message..... another alternative if you are able to and if the HOA is ok with this. Get a couple of tow away...

well I've got a solution.. you may not like it but if you have a valve stem remover you can just ever so slightly turn the valve stem till it leaks out very slowly or take it out completely and after a few times of this they will get the message.

I had the same thing happend on my 2006 4 runner when i disconnected the battery to replace the radio. There is a step to get this all to work and its in the manual if iam right. you have to zero point the back window for the defroster wiper auto front window and sunroof to work... kind of a...

Sound like to me a crack in the head or block.... I had a similar thing happen on a frontier of mine. the funny thing was I tested the compression and did a pressure test on the coolant system and all seemed fine.

I know its been awhile since i responded. Kinda got into my saltwater tank hobby... But i tried the calibration and all i get is a flashing abs light and nothing goes off. I did try to plug a code scanner into it and i keep getting a right rear abs code but the abs does work i tried it out. I...

this has been bugging the he!! out of me for a couple days now and I am out of ideas.. Recently my pinion bearing went out and I had to pull the third member out... in the proccess of doing removing the axles I broke an ABS sensor and the ABS, BRAKE!, VSC, and the car with squiggly lines lights...

All right I have an 06 v6 2wd and the rear end is starting to howl. Now I know it needs a new third member and I have found one. My questions are should I rebuild this on that I have in my truck? I found a company in NC called east coast gear supply and they will do it for 700 bucks or should I...

06 with 116k

crap was hoping that i didn't need to set it lol.

Took her in today to get the rear-end checked out by a buddy of mine because of the noise coming from the rear-end and turThanks i need a pinion bearing. My question is does this rear-end need to have the backlash set once I pull the pinion out or is this just just like a Ford 9inch which...