Recent content by thehaitian

  1. thehaitian

    Kenwood TM-V71 separation cable alternative

    So I just bought a Kenwood TM-V71 unit; figuring it would be like my D710A I was just going to use CAT5 for the separation cable. To my surprise the face-plate does not take standard CAT5. And, to buy a cable online, the cheapest I found was 44 bucks. After inspecting it, I figured I could...
  2. thehaitian

    Will I FUBAR anything if

    Awesome. I figured as much with all the flex in that plastic, but I'm always cautious about drilling in that area. Thanks
  3. thehaitian

    Will I FUBAR anything if

    I drill some self tapping screws into center console tunnel, in particular where I've highlighted? Thanks in advance.
  4. thehaitian

    theHaitians Ham Install

    Greetings, Recently I purchased a Kenwood TM-D710A to use as my mobile set-up. I figured I'd begin chronicling my install (with a 6 month old my time in the garage is limited) which I hope to have complete by this coming Saturday (5/11). The basic idea I'm going with is the face-plate mounted...
  5. thehaitian

    Original 2013 Limited Wheels

    I'm a noob and I'm getting tired of this.
  6. thehaitian

    Looking for a Cargo Carrier for rear hitch.

    Here you go TMS T-NSB-F6020 60-Inch Truck Car Mounted Folding Cargo Carrier Basket - Amazon.com
  7. thehaitian

    I'm on a diet....

    [No message]
  8. thehaitian

    Official T4R "Firearms" thread

    My SBR build
  9. thehaitian

    I'm on a diet....

    ...and I figured I'd share it with y'all. I know I'm new here, but I (poorly) write a satirical blog. If only one of you guys like it, then I call it a success. Hope you enjoy (if profanity offends you, move along). Enjoy: theHaitianActual v2.1: Yea I'm on a diet. What?
  10. thehaitian

    AR15 Package FS - GA Residents Only

    I may sell the ammo separate at a later time if I sell the rifle separately. For now it stays as a package.
  11. thehaitian

    Grinding off antenna support tab

    on the 2013 limited (cant speak for any other), the hatch doesnt get flush until above the tail lights where the hatch wraps around to the side of the body. I can do above, which I'll most likely end up doing, but i already have a 5 foot stick.
  12. thehaitian

    Grinding off antenna support tab

    Hey guys, I want to see if any of you think there would be an issue with this idea. (I tried multiple searches but had no luck). I bought a Comet HD-5-3/8-24, and the only flush place to mount it on my rear hatch (2013 4runner) is towards the upper end of the hatch; however I'd ideally like to...
  13. thehaitian

    What did you do to/in your 5th Gen today?!

    Installed under hood LED's. Wired CB for power (waiting on antennae mount). Got rid of hydrocarbon filter. Today was a good day.
  14. thehaitian

    AR15 Package FS - GA Residents Only

    Granted I've only shot 90 rounds through it, but the battle comp did it's job.
  15. thehaitian

    How Many 5th Gen Military Members On Here???

    Active/Reserve/Retired: Veteran Branch of Military: USMC Years Served: 2002-06 Paygrade: E4 MOS/Rate: 0341 - Mortars

Members online

Forum statistics

Threads
278,312
Messages
3,554,083
Members
248,016
Latest member
Advally Service
Back
Top