Recent content by wyanrard

haha, does look familia, wish I had the V8 though! haha. I've only got about $100 invested in lights and pig tail adapter, plus the bulb cost.

#MALLCRAWLALLDAY Used it for work today. Haha.

Uhh, probably around 20k miles or more. No problems so far.

Well then, I'm glad we're on the same page. :trophy:

How awkward would it be of me to come and just hug your truck? haha :zoom:

It was a stretch, but I got all bushings and 4 washers to fit on each arm, took 2 people, but I've had no problems, I tried 2, and had a terrible clunking noise.

Definitely appears to be an aftermarket spindle, this was just strange to look at. haha.

Drilled, tapped and replaced a bolt on my transmission pan.

I got it at random times as well, not just while turning.

Torque UCA and LCA correctly? Could also possible be tie rods.

Its worth a shot. I had the same problem reverse/turning.

I'm local as well, i read where you have the thud when backing? Have you solved this? I just did, Torqued the lower control arm cam bolts to 105 ft/lbs (torque spec is 100 ft/lbs I believe.) and I also made sure that my UCAs were torqued to 85 ft/lbs. This solved my clunk/thud noise. I run the...

I'll be in missouri later this year.

Probably going to need to replace the lower bushings in them. Taco uses 1/2" I believe, 4runner/FJ use 3/4".

Unfortunately, the only place I could find that did road force balance at the time was really expensive. When the tires were finally pulled off the wheel, looking inside it appeared as if a belt had slipped, or that during the manufacturing process had added a huge swelled/heavy spot. It was...