Recent content by YukonT4R

Sign of a good time!

I did my spare in black pasti dip as a test. It was all chipped up and gouged from being mounted facing down but the plasti dip filled it in very well. After I decide what tires I'm going with I'm going to go black or grey... Still haven't decided.

Installed this rocker switch to go with the lights

Installed a couple of LED reverse lights under the bumper last night

Ride quality is great with the OME883. A small amount stiffer than stock V6 4X4, the two wheel drive might have an even softer and or shorter spring... Not sure. You may get 2.5" to 3" lift with two wheel drive?? Not sure... But if you don't get enough lift you can always go up a notch on the...

I put Old Man Emu 883 coils on the front with the Bilsteins set at 0 lift and I am up about 2.5". I have a 07 V6 4X4. I though the OME 883 coils would only lift around 1.5", I was planning on moving up the Bilsteins one or two notches but don't need to now. The ride is great with the OME...

Just got this in the mail today. Cheap and it's small so you don't notice it. Lots of reviews and tips on you tube.

Dyea, Alaska

I have the the new Cooper A/TW 265/70/17 available at Canadian Tire. I drive in very similar conditions up here in the Yukon and these have been great so far. I put them on in Jan last year. Not that expensive, they seem to get great reviews and are rated for high mileage. Similar design to the...

Took the little one fishing. :fishing: Might be the last time this year, already ice starting on the lake.

Yup that way makes sense. Dust cap will fit this way. When assembled this way the second washer provided is left out... It doesn't make sense for it to go on the top.. Maybe it was for the older bolt design.

Suspension Marketplace was the ebay seller... They seemed like they were packed well for shipping. I suspect they damaged the paint when they pressed in the uniball.

Had a little paint damage when it arrived.. From pressing in the uniball I'm assuming.

Mine showed up in the mail today! Is the the correct order for the uniball bolt on a fourth gen? Don't want to mess it up and no instructions came with them. I have read some installs on third gens and the total chaos instructions but still a little confused...

NEW! Cool looking Old Man Emu BP-51 (Bypass 51mm Diameter Bore) Shock Absorbers. They look cool and are a little $$$$. Can't wait till someone buys these and reviews them for us.