I have 2021 Pro—the exhaust sound is very annoying. Sounds like there’s a small hole in the muffler. It just buzzes. For 50k, I expected a super cool tone. Very disappointing. Has anyone had any luck with an aftermarket muffler to improve the sound?
I have 2021 Pro—the exhaust sound is very annoying. Sounds like there’s a small hole in the muffler. It just buzzes. For 50k, I expected a super cool tone. Very disappointing. Has anyone had any luck with an aftermarket muffler to improve the sound?
I have about 5k on mine and I’m not a fan. Lots of drone going up moderate hills and inclines, makes the car feel like it’s struggling and accentuates the long gearing of the 5 speed. I was hoping it would mellow out with mileage but not much improvement.
Sent from my iPhone using Tapatalk
I made the switch. Kept the side outlet but swapped the muffler.
SOOOO much better. The drone at when downshifting on express way was killing me.
Did you cut and swap the flanges? I'm pretty sure the stock one uses a 2-bolt flange and the TRD one uses a 3-bolt flange (post muffler).
I traded a 2018 TRD Pro for a 2021. I hate the exhaust on the ‘21. Volume is fine but the drone is super annoying. I like loud exhausts on sports cars but this thing sounds so much worse than the 2018. I asked my SA if he thought I could just get an exhaust for an ‘18 to put on the ‘21. He did not think it was possible. I’d love to make the change to a standard exhaust but this thread is full of talk about welding and flanges…. Seems like I might have to just live with it.
I’m open to the trade if we can get someone trustworthy to do the work. However, you’ll have to take my running boards as well![]()
I’m open to the trade if we can get someone trustworthy to do the work. However, you’ll have to take my running boards as well![]()
An update to my early September post above. The TRD exhaust now has around 6,500 miles on it. About a month ago, I installed about 9 square feet of 1/8" thick of mass loaded vinyl (MLV) on the cargo area floor. Luxury Liner: Mass Loaded Vinyl Sheets - Second Skin Audio
For the install, I removed the plastic trim piece on the floor near the rear door, lifted the carpet, floor panel, and styrofoam panel and then cut the MLV to fit the bare metal floor. I used spray adhesive to secure the MLV.
I have to say, either the exhaust continues to quiet down and/or the MLV took the edge off the exhaust. It is now quite acceptable during driving, even up hills on a downshift. The worst audible range of the TRD exhaust was 2500-3000rpms under load while going up a hill. It would resonant and boom the cabin if the rpms stayed within this range. This is still the loudest operating range of the exhaust, but it doesn't resonant and boom the cabin.
It's a relief because I was a bit worried taking the family on longer trips with a loud exhaust. That's no longer a worry. I actually somewhat like the sound now.