Dinardy
New member
285/75/16 Bridgestone Revo2
2nd Gen T4R Picture Gallery
- Thread starter RuSty420
- Start date
285/75/16 Bridgestone Revo2
89FourRunner
New member
Hey guys! I've been reading posts off this site for a long time! Figured I'd share my truck.
This is my 1992 hilux surf SSR-G. 2.4L turbo diesel with the 3L head. It's a 5spd and it has the full recaro interior! It's lifted 6 inches (all suspension) and its currently rolling on 35's
Wow where was this picture taken? That's a really nice shot. Nice truck too BTW.
EricHartley
New member
It was taken at the rocky point boat launch in port moody BC
mistersnowman97
New member
New sub in the back
Sorry not much of an exterior pic but enjoy!
mistersnowman97
New member
a bit of climbing and mudding 
With my bro with his landcruiser (1 week before he wrecked it
)
Easy drive to Long Lake in truckee, ca. Trail's real easy. some stuff to play on as well. real fine sand and dirt, easy to sink in on inclines!
With my bro with his landcruiser (1 week before he wrecked it
)
Easy drive to Long Lake in truckee, ca. Trail's real easy. some stuff to play on as well. real fine sand and dirt, easy to sink in on inclines!
Dinardy
New member
Installed BJ spacers and replaced the upper balljoints, T bars cranked slightly to avoid tire rub. The caster is way off now, will need to figure that out in due time... Waiting to go on the rear: 7 wrap rear LC coils, refurbished. FJ80 Bilstein 4600s, stock height, new. 4crawler 4in drop bracket.
P-Town-503
New member
Installed BJ spacers and replaced the upper balljoints, T bars cranked slightly to avoid tire rub. The caster is way off now, will need to figure that out in due time... Waiting to go on the rear: 7 wrap rear LC coils, refurbished. FJ80 Bilstein 4600s, stock height, new. 4crawler 4in drop bracket.
:thumb: This is how my rig looked before the transformation... looks very clean! post pics of the rear when installed. I have the same setup in front and I took my rig too the "lineup shop" on sandy for alignment if your having issues with that.
Dinardy
New member
Yeah I had firestone do an alignment... The caster ended up worse off than before lol. Good thing I didn't pay full price. I'm going to hit a front end shop up in Bellevue, Wa
Another poser shot after a nice bath. 51 degrees in the Pacific Northwest today!
mistersnowman97
New member
Where exactly in the pacific northwest? Like, washington? or norcal?
mikebontoft
New member
Just the most recent shot of it. Nothing new (besides the camera!). Going to build some lower profile sliders this time (the one I built before is just too big in my opinion). It's time for sliders. And a rear bumper.
Dinardy
New member
Western Washington, Puget Sound area
thatoneguy
New member
mikebontoft
New member
Got a little bit of a mess there.
Finally cleaned mine out and detailed it. Haven't done that since probably.... well. May of last year. Yeah.
Finally cleaned mine out and detailed it. Haven't done that since probably.... well. May of last year. Yeah.
NoleRunner95
New member
fo' runnin'
New member
Hey guys, new to the forum, here is my rig! 100% stock with a set of 33x10.50s...
DeclansDaddy
New member
Nice ride fo runnin. Do you have any rubbing issues on the street with that tire/wheel combo.
541joseph
New member
Hey guys, new to the forum, here is my rig! 100% stock with a set of 33x10.50s...
DId you make it any farther then that?
fo' runnin'
New member
YUP!
<iframe width="560" height="315" src="//www.youtube.com/embed/QwhJ6N6Y8XE" frameborder="0" allowfullscreen></iframe>
541joseph
New member
That's insane with a stock truck!
