50" curved light bar brackets for under $20

[fozzywozzy]

After searching and researching, nothing 4Runner specific looked good to me. So after about a week of comparing pictures and asking questions I decided to buy 2015 chevy light bar brackets.

It took was some grinding to get them narrow enough to fit into the rain gutters. All in all I'm pretty satisfied with how it all turned out.

Sent from my iPhone using Tapatalk

 

[2003-4x4runner]

Looks Great! Where did you buy them and what are the part # for the light bar and brackets. Also how/where did you run the power cord from the light bar?

Thank you.

 

[fozzywozzy]

Looks Great! Where did you buy them and what are the part # for the light bar and brackets. Also how/where did you run the power cord from the light bar?



Thank you.

The light bar is the 50" curved light bar made my light fox. I purchased it on Amazon. I bought it based on reviews and reviews were pretty good.

As for the brackets.. I got them on eBay
https://www.ebay.com/itm/191755919642

I bought MICtuning's wiring harness and their Toyota button

It fits right into the blank slots!

The power chord is ran between the two legs of the light bar bracket on the driver side (hole drilled and silicone to seal) a lot of silicone haha


Sent from my iPhone using Tapatalk

 

[07V8]

How's the wind noise?

 

[fozzywozzy]

How's the wind noise?

Wind noise? Oh its horrible! haha its like i have a 10" sub on my roof.. I've moved my cargo box up closer to it and its helped a little bit. I've been trying to figure out a solution. Some say that making a support in the middle of the light bar should dampen the vibrations.

We'll see.. i'll post something if i end up doing something that works.