FrenchToasty
New member
Just a fyi, my battery died on me out of the blue, scangauge read normal volts the entire time and no battery light. A bad cell in the battery can cause a no warning no crank/no start.
Check/wiggle all cables/grounds, bad gas should have caused sputtering, running rough/differently or something abnormal.
Just a thought, if the torque app couldn't pull the cel code, maybe it was a body/electrical code. Some scanners can't pick those up.
I had the same issue while camping, no warning, nothing out of the normal; parked it to feed the little one and left accessories on for 2 minutes without it running, wouldn't start at all. Luckily got a jump from a old fart leaving the fishing hole, drove it home 300 miles with no issue. Made sure to leave it on when I had to fuel. Had a bad cell and low water, go figure in az heat!