Anybody got pictures of toytecs lifts and reviwes

[Jskc1026]

Try to build my daily just trying to see what's best thanks for the info

 

[Jeremy556]

Nope. Never been done before. And certainly not in the tacked 125 page thread at the top of this forum.

 

[Hillbilly Mac]

I can tell you that their spanner wrenches f'n suck. This happened twice: original spanner & replacement.

& since they come preset to 2 1/2" my truck looked like this for a week.

BUT, now that they're FINALLY set to 1", I love the hell out of them. I got this btw.

 

[eddiebx]

I can tell you that their spanner wrenches f'n suck. This happened twice: original spanner & replacement.


http://www.macmcpherson.com/wp-content/uploads/2014/03/wtf2.jpg[/]


& since they come preset to 2 1/2" my truck looked like this for a week.


[IMG]http://www.macmcpherson.com/wp-content/uploads/2014/03/wtf.jpg[/]


BUT, now that they're FINALLY set to 1", I love the hell out of them. I got [B][URL="http://toyteclifts.3dcartstores.com/ToyTec-Coil-Overs-FJ-03-UP-4Run-05-UP-Tacoma_p_13.html"]this[/URL][/B] btw.[/QUOTE]

Damn that sucks, by any chance are you adjusting the coilovers with the weight of truck on the ground or jacked up in the air?

Looks like the way they casted the little finger into the wrench just sucks...

Have you tried sourcing a pair of these cheap stamped steel kind?

[img]http://espimages.biz/2386/I/541/7/images_FGFFKFKKK.jpg

I've never had one fail, but then again I don't crank the shiet out of the collars either, lol.

 

[philsey]

Try to build my daily just trying to see what's best thanks for the info

Shhhhh, quiet ..... hear that? It's [MENTION=66316]1engineer[/MENTION] grinding his teeth.

 

[Hillbilly Mac]

Damn that sucks, by any chance are you adjusting the coilovers with the weight of truck on the ground or jacked up in the air?

Looks like the way they casted the little finger into the wrench just sucks...

Have you tried sourcing a pair of these cheap stamped steel kind?

I've never had one fail, but then again I don't crank the shiet out of the collars either, lol.

I had it at a shop, getting them put on along with the tires, so it was up on a lift, wheels off. I snagged a smaller steel spanner & they cut that off & welded it to the ToyTec spanner to get the job done. & they still bent the living sheeeit out of the wrench. All of the good spanners I've found are mostly for slotted collars. I guess I could round it off & make it work. I have a feeling I'm going to go with OME down the line & swap the ToyTec over to teh Trail I'm going to buy my Household 6 (wife, for all you non-military folks). I HAVE talked to Kevin at ToyTec & he's trying to get the spanners changed.

Shhhhh, quiet ..... hear that? It's [MENTION=66316]1engineer[/MENTION] grinding his teeth.

I heard his head explode from here, about 2 hours away...blew out the windows! :rip:

 

[mace.]

My spanner broke after the doing the first coil over. I was able to use a strap wrench to lower the other side. Not sure if it would work to try and raise the front up.