body mount issue
- Thread starter roger123
- Start date
Register to hide this ad
T4R2014
Elite Member
I have no experience with them but this vendor has been around for as long as I can recall (10+ years).
4Crawler Offroad - Custom Body Lift Kits
4Crawler Offroad - Custom Body Lift Kits
garrett1478
New member
I installed a set of poly body mount bushings from 4crawler a long time ago but removed them and stuck with my stock rubber bushings. The poly seemed to transmit more road bumps/vibration. But it may not be as bad if you are not replacing all of them with poly. Also I imagine something is better than nothing LOL.
I think I still have them stashed away somewhere, I will check.
I think I still have them stashed away somewhere, I will check.
Last edited:
reply
I have not yet attempted to do any replacement ,due to the fact I am not sure if i need all 10 bushings, the rt mount under the dash seems to be the worst.pulled the rug back and the floor is cracked. The bolt head is rusted so badly that I won,t be able to put a socket on it. I did check out 4 crawler off road and could not find the part...Auto Parts Warehouse has a universal bushing kit that only supplies 2 bushings...I would prefer to change all of them . if I could find a kit that would give me all 10 bushings I would be all set. hopefully some one can direct me to a supplier...thanks
I have not yet attempted to do any replacement ,due to the fact I am not sure if i need all 10 bushings, the rt mount under the dash seems to be the worst.pulled the rug back and the floor is cracked. The bolt head is rusted so badly that I won,t be able to put a socket on it. I did check out 4 crawler off road and could not find the part...Auto Parts Warehouse has a universal bushing kit that only supplies 2 bushings...I would prefer to change all of them . if I could find a kit that would give me all 10 bushings I would be all set. hopefully some one can direct me to a supplier...thanks
Last edited:
Doc2012
Senior Member
If your floor is cracked, you're basically f'd.
You need to cut and weld a new piece there, or find a way to fix it.
BrianSD_42
New member
I'd just like to mention that I did 4Crawlers 1" body lift AND I also did a complete body mount swap. I now have poly all around and I'm quite happy.
reply
Pulled out all the seats quarter trim panels,rug was wet...loosened off 7 of the 10 body mounts ...both frt bolts under the dash and the rt rear under pass seat seized. drivers floor pan is very close to the flinstone car. I guess I will be busy over the next month. Going to check my a/m supplier for a floor pan.
Pulled out all the seats quarter trim panels,rug was wet...loosened off 7 of the 10 body mounts ...both frt bolts under the dash and the rt rear under pass seat seized. drivers floor pan is very close to the flinstone car. I guess I will be busy over the next month. Going to check my a/m supplier for a floor pan.
BrianSD_42
New member
Also read this thread ..... http://www.toyota-4runner.org/3rd-gen-t4rs/168410-toytec-1-body-lift.html
