bug shield

[Ltmaestro1]

i am debating between the Focus 4Runner Form fit Hood Deflector from carson toyota or just odering the regular toyota bug shield. Any suggestions which one is better?

 

[AlexJet]

i am debating between the Focus 4Runner Form fit Hood Deflector from carson toyota or just odering the regular toyota bug shield. Any suggestions which one is better?

If you want a good Hood Deflector get the Canadian one, It covers larger area and looks better.

 

[wb2fcr]

Check out this thread:

http://www.toyota-4runner.org/showthread.php?s=&threadid=13057


Dave

 

[00328]

I installed the CAN. version about two weeks ago. So far I like it alot. It hugs very close to the hood and since I have a black 4R almost looks like part of the vehicle. Not sure how I'm going to clean underneath it yet, maybe just slide a wet rag between it and the hood.
Have only been on the highway a couple times since installation and only up to about 70-75 mph, so far no shimmies or shakes. I just didn't like the way the US version stuck up so high.
I did find the install a little tricky though.

 

[AlexJet]

I installed the CAN. version about two weeks ago. So far I like it alot. It hugs very close to the hood and since I have a black 4R almost looks like part of the vehicle. Not sure how I'm going to clean underneath it yet, maybe just slide a wet rag between it and the hood.
Have only been on the highway a couple times since installation and only up to about 70-75 mph, so far no shimmies or shakes. I just didn't like the way the US version stuck up so high.
I did find the install a little tricky though.

I'm using pressurized water to clean under it. Works fine so far.